1 GL of  Concrete/Masonry Sealer  COLOR: Slate Grey (CMFPS) Interior/ Exterior
Great For Porches, Patios, Decks, AND Walkways
Color: Slate Grey
Lot# 101320
Desert Brand Concrete/Masonry  Sealer (CMFPS)
is a superior performance, acrylic latex floor coating formulated to enhance and protect new or aged concrete/masonry walking surfaces including previously sealed magnesium oxychloride floors, decks, and stairs. Its durable, low luster finish seals concrete/masonry porches, patios, decks, and walkways providing a deep penetrating, scuff-resistant finish.
CLEAN SURFACE:
• Make sure surface is free of grease, oil, dirt, wax, or other foreign matter. • If necessary scrape or wire brush and sand previously applied coatings.
PREPARE SURFACE:
• To control efflorescence on new or unpainted concrete use Desert Brand Etch-Off or other acid solution.
Rinse and neutralize thoroughly.
Allow a minimum of 24 hours to dry.
For all masonry repairs use Desert Brand Concrete/Masonry crack filling and
patching products.
Apply a small amount of sealer to test for possible lifting.
APPLICATION:
• Stir contents thoroughly.
• Use a synthetic or nylon bristled brush or a nap roller .
• For smooth surface use 1/4” nap roller and for a rough surface use 3/8”-1/2”
nap roller.
• Apply an even coating when surface temperature is between 55° and 85°F.
DOUBLE UP:
• Two thin applications may be necessary depending upon surface porosity.
• Allow 24 hours between coats.
• Drying and recoat times are dependent on temperature, humidity and film
thickness.
PRECAUTIONS:
• Foot traffic should remain off of the sealed surface for 24 hours.
• For heavy foot traffic, allow 72 hours.
• CMFPS is not recommended for concrete garage floors or other surfaces
where vehicles are parked, tires may cause some lifting of the coating.
• Do not allow CMFPS to freeze, material will not thaw to a usable product.
CLEANING OF EQUIPMENT:
• Equipment and hands may be cleaned with mild liquid detergent and water. • Dry material can be removed with acrylic lacquer thinner, follow
manufacturer’s cautions.
• Disposal of any unused material must comply with local, state, and federal
regulations.
TINTING:
• White Base CMFPS may be tinted to achieve a desirable pastel shade. Use universal colorants only and do not exceed 4 oz. of tint to one gallon.
Warning: Possible Slipperiness – Like any quality finish, CMFPS reduces the porosity of the surface being sealed. Be aware that oil, water, mud, or other materials on a sealed walkway can make the surface slippery and therefore, potentially dangerous. Good housekeeping and maintenance are important, proper drainage is imperative.